TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 911 of 1760
CONTINUITY TEST (1) Remove nut, lockwasher, terminal lug TL16 and lockwasher from LH rear marker light screw. Discard lockwashers. (2) Set multimeter to ohms. (3) Connect positive (+) probe of multimeter to terminal lug TL16. (4) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (5) If continuity is not present, repair wire 3094 from terminal lug TL16 to ground (para 2-40) and go to step 5 of this fault if required or replace rear lights cable assembly (para 7-75) and go to step 1 of this fault. (6) If continuity is present, repair wire 489 from splice E15 to splice E16 (para 2-40) and go to step 5 of this fault if required or replace rear lights cable assembly (para 7-75) and go to step 1 of this fault. (7) Install lockwasher, terminal lug TL16, lockwasher, and nut on LH rear marker light screw. Change 1 2-584.25 TM 9-2320-365-20-1