TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 883 of 1760
Change 1 2-581 TM 9-2320-365-20-1 WARNING Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuits and cause severe burns or electrical shock. CAUTION Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. Marker Light LH Side LH Rear Left Rear Middle Rear Right Rear RH Rear Connector P85 P86 P54 P56 P58 RH Side P89 P88 Connector P85 to Splice E16 Connector P86 to Splice E15 Connector P54 to Splice E15 Connector P56 to Splice E15 Connector P58 to Splice E15 Connector P89 to Splice E17 Connector P88 to Splice E17 Wire 489 Segment NOTE Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. VOLTAGE TEST (1) Disconnect marker light connector from connector (refer to Table 2-12. Side and Rear Marker Light Connectors). (2) Set multimeter to volts DC. (3) Connect positive (+) probe of multimeter to connector (refer to Table 2-12. Side and Rear Marker Light Connectors). (4) Connect negative (-) probe of multimeter to ground. (5) Position main light switch to SER DRIVE (TM 9-2320-365-10) and note reading on multimeter. (6) Position main light switch to OFF (TM 9-2320-365-10). (7) If 12 VDC is not present, repair wire 489 (refer to Table 2-12. Side and Rear Marker Light Connectors) (para 2-40) or replace rear lights cable assembly (para 7-75). Table 2-12. Side and Rear Marker Light Connectors