TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 879 of 1760
Change 1 2-578.13 TM 9-2320-365-20-1 CAUTION Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. NOTE Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. CONTINUITY TEST (1) Disconnect batteries (para 7-48). (2) Remove PDP cover (para 16-2). (3) Remove three screws and washers from PDP. (4) Remove three screws from PDP. (5) Lift PDP outward to gain access. (6) Disconnect connector P51 from connector J51. (7) Set multimeter to ohms. (8) Connect positive (+) probe of multimeter to connector J51 pin 7. (9) Connect negative (-) probe of multimeter to terminal board TB1 position 11 and note reading on multimeter. (10) If continuity is not present, repair wire 489 from connector J51 pin 7 to terminal board TB1 position 11 (para 2-40) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (11) If continuity is present, repair wire 489 from connector P51 socket 7 to splice E15 (para 2-40) or replace rear lights cable assembly (para 7-75). (12) Connect connector J51 to connector P51. (13) Install PDP on dashboard with three screws. (14) Install three washers and screws in PDP. (15) Install PDP cover (para 16-2). (16) Connect batteries (para 7-48).