TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 853 of 1760
Change 1 2-567 TM 9-2320-365-20-1 CONTINUITY TEST Light Table 2-11.2. Cab Clearance and Marker Light Terminal Lugs Terminal Lug Wire Segment (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to terminal lug (refer to Table 2-11.2. Cab Clearance and Marker Light Terminal Lugs). (3) Connect negative (-) probe of multimeter to to ground and note reading on multimeter. (4) If continuity is not present, repair wire 3097 (para 2-40) or replace cab clearance and marker lights cable assembly (para 7-59) or M1081 cab clearance and marker lights upper cable assembly (para 7-56). (5) If continuity is present, replace marker light assembly (para 7-31). (6) Install gasket on marker light base. (7) Connect connector (refer to Table 2-11.2. Cab Clearance and Marker Light Connectors) to marker light connector. (8) Install lockwasher, terminal lug (refer to Table 2-11.2. Cab Clearance and Marker Light Terminal Lugs), lockwasher, and nut on back of base. (9) Install marker light base on vehicle with four screws. (10) Install marker light lamp in socket. (11) Install lens cover on base with two screws. RH Cab Top Marker Light RH Cab Top ID Light Middle Cab Top ID Light LH Cab Top ID Light LH Cab Top Marker Light TL3 TL4 TL8 TL22 TL27 TL3 to splice E24 TL4 to splice E24 TL8 to splice E24 TL22 to splice E24 TL27 to splice E24