TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 799 of 1760
TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 2-533 2-533 2-533 2-533 2-533 CONTINUITY TEST CONTINUITY TEST (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to connector P18-3. (3) Connect negative (-) probe of multimeter to connector P18-2. (4) If continuity is not present, replace turn signal switch (para 7-25). (5) If continuity is present, repair wire 16A (para 2-40) or replace WETC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (6) Connect connector P18 to connector J18. (7) Install instrument panel assembly (para 7-15). (8) Install relay K8 in PDP. (9) Install PDP cover (para 16-2). (1) Remove three screws and washers from PDP. (2) Remove three screws from PDP. (3) Lift PDP outward to gain access. (4) Disconnect connector J27 from connector P27. (5) Set multimeter to ohms. (6) Connect positive (+) probe of multimeter to PDP, relay K8 terminal 30, where relay K8 was removed. (7) Connect negative (-) probe of multimeter to connector J27-6 and note reading on multimeter. (8) If continuity is not present, repair wire 17 (para 2-40) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (9) If continuity is present, repair wire 17 (para 2-40) or replace front lights cable assembly (para 7-74). (10) Connect connector P27 to connector J27. (11) Install PDP in dashboard with three screws. (12) Install three washers and screws in PDP. (13) Install relay K8 in PDP. (14) Install PDP cover (para 16-2).