TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 713 of 1760
CONTINUITY TEST (13) Tighten four screws to 6-10 lb-in. (1 N·m). (14) Connect batteries (para 7-48). (1) Loosen four captive screws in lamp mounting panel. (2) Remove lamp mounting panel from lighted indicator display housing. (3) Remove emergency brake indicator lamps from printed circuit board. (4) Set multimeter to ohms. (5) Check continuity through each emergency brake indicator lamp and note reading on multimeter. (6) If continuity is not present in both lamps, replace lamps (para 7-16). (7) If continuity is present in either lamp, replace lighted indicator display (para 7-16). (8) Install emergency brake indicator lamps in printed circuit board. (9) Install lamp mounting panel in lighted indicator display housing. (10) Tighten four captive screws in lamp mounting panel. (11) Connect lighted indicator display to connector PX7. (12) Position lighted indicator display in instrument panel assembly with four screws. TM 9-2320-365-20-1 Change 1 2-453