TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 681 of 1760
TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 2-421 2-421 2-421 2-421 2-421 CONTINUITY TEST (1) Remove PDP cover (para 16-2). (2) Remove three screws and washers from PDP. (3) Remove three screws from PDP. (4) Lift PDP outward to gain access. (5) Disconnect connector P111 from connector J111. (6) Set multimeter to ohms. (7) Connect positive (+) probe of multimeter to connector P110-S. (8) Connect negative (-) probe of multimeter to connector P111-G and note reading on multimeter. (9) If continuity is not present, replace CTIS cable assembly (para 7-53). (10) If continuity is present, repair wire 1911 (para 2-40) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (11) Connect connector P111 to connector J111. (12) Install PDP on dashboard with three screws. (13) Install three washers and screws in PDP. (14) Install PDP cover (para 16-2). (15) Connect lighted indicator display to connector PX7. (16) Position lighted indicator display in instrument panel assembly with four screws. (17) Tighten four screws to 6-10 lb-in. (1 N·m).