TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 641 of 1760
TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 2-397 2-397 2-397 2-397 2-397 VOLTAGE TEST Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. WARNING (1) Set multimeter to volts dc. (2) Connect positive (+) probe of multimeter to "A" switch connector terminal 1. (3) Connect negative (-) probe of multimeter to ground. (4) Position main light switch auxiliary lever to PANEL BRT (TM 9-2320-365-10). (5) Position dimmer switch to maximum brightness (TM 9-2320-365-10). (6) Position main light switch to SER DRIVE (TM 9-2320-365-10) and note reading on multimeter. (7) If 12 vdc is not present, repair wire 1908 (para 2-40) or replace auxiliary panel cable assembly (all models except M1079 w/o winch) (para 7-49) or M1079 w/o winch auxiliary panel cable assembly (para 7-50). (8) If 12 vdc is present, repair wire 3020 (para 2-40) or replace auxiliary panel cable assembly (all models except M1079 w/o winch) (para 7-49) or M1079 w/o winch auxiliary panel cable assembly (para 7-50). (9) Position main light switch to OFF (TM 9-2320-365-10). (10) Connect PTO switch connector to PTO switch. (11) Position auxiliary panel on auxiliary panel housing with six screws. (12) Tighten six screws to 24 lb-in. (3 N·m).