TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 619 of 1760
WARNING Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuits and cause severe burns or electrical shock. CAUTION Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. VOLTAGE TEST (1) Install circuit breaker CB70 on PDP. (2) Set multimeter to volts DC. (3) Connect positive (+) probe of multimeter to connector PX15 socket F. (4) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (5) If 12 VDC is not present, repair wire 1586 from connector PX15 socket F to circuit breaker CB70 socket 4 (para 2-40) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). Change 1 2-384.1 TM 9-2320-365-20-1