TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 613 of 1760
CONTINUITY TEST Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. NOTE Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. CAUTION Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuits and cause severe burns or electrical shock. WARNING (10) Position main light switch auxiliary lever to OFF (TM 9-2320-365-10). (11) Position main light switch main selector lever to OFF (TM 9-2320-365-10). (12) Disconnect dimmer switch test wire from dimmer switch connector. (13) Disconnect dimmer switch test wire from connector PX24. (1) Position dimmer switch for maximum brightness (TM 9-2320-365-10). (2) Install dimmer switch test wire pin in connector PX24 socket 1. (3) Install dimmer switch test wire socket on dimmer switch connector pin 1. (4) Set multimeter to volts DC. (5) Connect positive (+) probe of multimeter to dimmer switch connector socket 2. (6) Connect negative (-) probe of multimeter to ground. (7) Position main light switch main selector lever to SER DRIVE (TM 9-2320-365-10). (8) Position main light switch auxiliary lever to PNL BRT (TM 9-2320-365-10) and note reading on multimeter. (9) If 12 VDC is not present, replace dimmer switch (para 7-12). Change 1 2-380.25 TM 9-2320-365-20-1