TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 523 of 1760
VOLTAGE TEST (12) Connect connector P913 to connector J913, if required. (13) Install personnel heater assembly (para 18-9). (14) Install instrument panel assembly (para 7-15). (1) Remove personnel heater for access (para 18-9). (2) Disconnect connector P913 from connector J913, if required. (3) Set multimeter to volts DC. (4) Connect positive (+) probe of multimeter to connector J913 socket 9. (5) Connect negative (-) probe of multimeter to ground. (6) Position master power switch to on (TM 9- 2320-365-10) and not reading on multimeter. (7) If 24 VDC is not present, go to step 4 of this fault. (8) If 24 VDC is present, repair wire 1546 from connector J913 socket 9 to connector PX10 pin 3 (para 2-40) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (9) Position master power switch to off (TM 9-2320-365-10). (10) Connect connector PX10 to VOLTS gage connector. (11) Connect connector clamp on VOLTS gage connector. WARNING Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuits and cause severe burns or electrical shock. CAUTION Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. NOTE Change 1 2-346.5 TM 9-2320-365-20-1