TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 369 of 1760
CONTINUITY TEST (1) Remove three screws and washers from PDP. (2) Remove three screws from PDP. (3) Lift outward to gain access. (4) Remove nut, lockwasher, terminal lug TL190, and terminal lug TL57 from grounding stud. Discard lockwasher. (5) Set multimeter to ohms. (6) Connect positive (+) probe of multimeter to terminal lug TL57. (7) Connect negative (-) probe of multimeter to terminal lug TL56 and note reading on multimeter. (8) If continuity is not present, replace PDP to cab ground cable (para 7-76). (9) If continuity is present, repair wire 1603 from terminal X3 on PDP to terminal board TB2 position 1 on PDP (para 2-40) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (10) Install terminal lug TL190 and terminal lug TL57 on grounding stud with lockwasher and nut. screws. (12) Install three washers and screws in PDP. (13) Install PDP cover (para 16-2). (14) Connect batteries (para 7-48). Change 1 2-256.11 TM 9-2320-365-20-1 (11) Install PDP on dashboard with three