TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 345 of 1760
Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. CAUTION NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back or not capable of making good contact. CONTINUITY TEST (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to neutral start relay socket 86 on VIM. (3) Connect negative (-) probe of multimeter to VIM connector pin K1 and note reading on multimeter. (4) If continuity is not present, replace WTEC II vehicle interface module (VIM) (para 8-6). (5) If continuity is present, repair wire 3101 from connector PX33 socket K1 to terminal board TB2 position 16 on PDP (para 2-40) or replace WTEC II dashboard cable assembly (para 7-10). (6) Install neutral start relay in VIM. (7) Install cover on VIM with metal seal ring, eight washers, and screws. (8) Connect connector PX33 to VIM connector. (9) Tighten screw in connector PX33. (10) Install circuit breaker CB35 in PDP. (11) Install kick panel (para 16-3). Change 1 2-243 TM 9-2320-365-20-1