TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 343 of 1760
CONTINUITY TEST Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. CAUTION NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back or not capable of making good contact. (1) Remove instrument panel for access (para 7-15). (2) Disconnect connector J114 from WTEC II transmission ECU pushbutton shift selector (TEPSS). (3) Set multimeter to ohms. (4) Connect positive (+) probe of multimeter to connector J114 socket 23. (5) Connect negative (-) probe of multimeter to connector J116 socket D1 and note reading on multimeter. (6) If continuity is not present, replace WTEC II cab transmission wiring harness (para 7-86). (7) If continuity is present, replace WTEC II transmission ECU pushbutton shift selector (TEPSS) (para 8-2). (8) Connect connector J114 to WTEC II transmission ECU pushbutton shift selector (TEPSS). (9) Install instrument panel (para 7-15). (10) Connect connector J116 to VIM connector. (11) Tighten screw on connector J116. (12) Install kick panel (para 16-3). (13) Connect batteries (para 7-48). Change 1 2-241 TM 9-2320-365-20-1