TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 341 of 1760
CONTINUITY TEST Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. CAUTION NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back or not capable of making good contact. (1) Disconnect batteries (para 7-48). (2) Loosen screw on connector J116. (3) Disconnect connector J116 from VIM connector. (4) Set multimeter to ohms. (5) Connect positive (+) probe of multimeter to neutral start relay socket 85 on VIM. (6) Connect negative (-) probe of multimeter to VIM connector pin P1 and note reading on multimeter. (7) If continuity is not present, replace WTEC II vehicle interface module (VIM) (para 8-6). (8) Install neutral start relay in VIM. (9) Install cover on VIM with metal seal ring, eight washers, and screws. (10) Install circuit breaker CB35 in PDP. Change 1 2-239 TM 9-2320-365-20-1