TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 307 of 1760
CONTINUITY TEST Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. CAUTION NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back or not capable of making good contact. (10) Install relay K11 in PDP. (11) Install power distribution panel (PDP) cover (para 16-2). (12) Connect batteries (para 7-48). (1) Remove instrument panel for access (para 7-15). (2) Disconnect connector J31 from connector P31. (3) Set multimeter to ohms. (4) Connect positive (+) probe of multimeter to connector J31 pin 21. (5) Connect negative (-) probe of multimeter to relay K11 socket 85 on PDP and note reading on multimeter. (6) If continuity is not present, repair wire 34 from relay K11 socket 85 on PDP to connector J31 pin 21 (para 2-40) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (7) If continuity is present, repair wire 34 from connector P31 socket 21 to connector P34 socket 2 (para 2-40) or replace engine control cable assembly (para 7-72). (8) Connect connector J31 to connector P31. (9) Install instrument panel (para 7-15). Change 1 2-205 TM 9-2320-365-20-1