TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 303 of 1760
CONTINUITY TEST (8) If continuity is present, repair wire 1929 from circuit breaker CB77 socket 5 on PDP to terminal board TB1 position 64 (para 2-40) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (9) Install PDP on dashboard with three screws. (10) Install three washers and screws in PDP. (11) Install relay K11 in PDP. (12) Install PDP cover (para 16-2). Change 1 2-201 TM 9-2320-365-20-1 (1) Remove three screws and washers from PDP. (2) Remove three screws from PDP. (3) Lift PDP outward to gain access. (4) Set multimeter to ohms. (5) Connect positive (+) probe of multimeter to relay K11 socket 30 on PDP. (6) Connect negative (-) probe of multimeter to terminal board TB1 position 64 on PDP and note reading on multimeter. (7) If continuity is not present, repair wire 1658 from relay K11 socket 30 on PDP to terminal board TB1 position 64 (para 2-40) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (13) Connect batteries (para 7-48).