TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 273 of 1760
CONTINUITY TEST Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. CAUTION NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back or not capable of making good contact. (1) Disconnect batteries (para 7-48). (2) Apply adhesive to auxiliary starter solenoid. (3) Apply adhesive to solenoid right terminal stud. (4) Disconnect connector clamp from oil pressure switch connector. (5) Disconnect connector P34 from oil pressure switch connector. (6) Set multimeter to ohms. (7) Connect positive (+) probe of multimeter to oil pressure switch connector socket 1. (8) Connect negative (-) probe of multimeter to oil pressure switch connector pin 2 and note reading on multimeter. (9) If continuity is not present, replace oil pressure switch (para 7-40). Change 1 2-171 TM 9-2320-365-20-1