TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 1507 of 1760
TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 2-1081 2-1081 2-1081 2-1081 2-1081 VOLTAGE TEST Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. WARNING (1) Remove instrument panel assembly for access (para 7-15). (2) Disconnect connector J43 from connector P43. (3) Set multimeter to volts dc. (4) Connect positive (+) probe of multimeter to connector J43-9. (5) Connect negative (-) probe of multimeter to ground. (6) Position master power switch to on (TM 9-2320-365-10) and note reading on multimeter. (7) If 24 vdc is not present, repair wire 1481 (para 2-40) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (8) If 24 vdc is present, repair wire 1481 (para 2-40) or replace start and charging cable assembly (para 7-82). (9) Position master power switch to off (TM 9-2320-365-10). (10) Connect connector J43 to connector P43. (11) Install instrument panel assembly (para 7-15).