TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 1465 of 1760
TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 2-1039 2-1039 2-1039 2-1039 2-1039 CONTINUITY TEST OPERATIONAL TEST (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to connector PX34-2. (3) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (4) If continuity is not present, repair wire 3011 (para 2-40) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (5) Connect connector PX34 to fan solenoid. (1) Remove air hose from fan solenoid. (2) Start engine (TM 9-2320-365-10) and allow air pressure to build up to normal level. (3) Position radiator fan off switch to on (TM 9-2320-365-10). (4) If air pressure is not present, replace fan solenoid (para 7-23). (5) If air pressure is present, replace fan clutch (para 6-14). (6) Position radiator fan off switch to off (TM 9-2320-365-10). (7) Position master power switch to off (TM 9-2320-365-10). (8) Connect wire 1807 to terminal board TB1 terminal 38. (9) Install PDP on dashboard with three screws. (10) Install three washers and screws in PDP. (11) Install air hose on fan solenoid. (12) Install kick panel (para 16-3).