TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 1457 of 1760
TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 2-1031 2-1031 2-1031 2-1031 2-1031 VOLTAGE TEST Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. WARNING CONTINUITY TEST (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to connector P36-1. (3) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (4) If continuity is not present, go to step 5 of this fault. (5) If continuity is present, fault corrected. (6) Connect connector P36 to water temperature switch connector. (7) Connect connector clamp on water temperature switch connector. (1) Set multimeter to volts dc. (2) Connect positive (+) probe of multimeter to connector P36-2. (3) Connect negative (-) probe of multimeter to ground. (4) Position master power switch to on (TM 9-2320-365-10) and note reading on multimeter. (5) If 24 vdc is not present, go to step 4 of this fault. (6) Position master power switch to off (TM 9-2320-365-10).