TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 1375 of 1760
VOLTAGE TEST Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuits and cause severe burns or electrical shock. TM 9-2320-365-20-1 Change 2 2-959 WARNING (1) Remove four nuts, washers, solenoid bracket, washers, and screws. (2) Loosen screw and disconnect winch out solenoid L5 connector from solenoid L5. (3) Set multimeter to volts DC. (4) Connect positive (+) probe of multimeter to winch out solenoid L5 connector terminal 1. (5) Connect negative (-) probe of multimeter to ground. (6) Position master power switch to on (TM 9-2320-365-10). (7) Position PTO switch to on (TM 9-2320-365-10). (8) Position winch power switch to on (TM 9-2320-365-10). (9) Position WINCH IN/OUT switch to OUT (TM 9-2320-365-10) and note reading on multimeter. (10) If 24 VDC is not present, go to step 3 of this fault. (11) Position winch power switch to off (TM 9-2320-365-10). (12) Position PTO switch to off (TM 9-2320-365-10). (13) Position master power switch to off (TM 9-2320-365-10).