TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 1329 of 1760
TM 9-2320-365-20-1 CONTINUITY TEST CONTINUITY TEST Change 2 2-918.15 (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to connector P84 socket A. (3) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (4) If continuity is not present, repair wire 3032 from connector P84 socket A to terminal lug TL85 (para 2-40) or replace start and charging cable assembly (para 7-82). (5) Connect connector P84 to air pressure switch. (1) Disconnect connector P110 from CTIS ECU. (2) Remove kick panel (para 16-3). (3) Disconnect connector P111 from connector J111. (4) Set multimeter to ohms. (5) Connect positive (+) probe of multimeter to connector P111 pin F. (6) Connect negative (-) probe of multimeter to connector P110 socket T and note reading on multimeter. (7) If continuity is not present, replace CTIS cable assembly (para 7-53).