TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 1271 of 1760
TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 2-875 2-875 2-875 2-875 2-875 VOLTAGE TEST Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. WARNING (1) Remove PDP cover (para 16-2). (2) Remove three screws and washers from PDP. (3) Remove three screws from PDP. (4) Lift PDP outward to gain access. (5) Disconnect connector PX22 from windshield wiper motor. (6) Set multimeter to volts dc. (7) Connect positive (+) probe of multimeter to connector PX22-4. (8) Connect negative (-) probe of multimeter to ground. (9) Position master power switch to on (TM 9-2320-365-10). (10) Position windshield wiper switch to high (TM 9-2320-365-10) and note reading on multimeter. (11) If 24 vdc is not present, go to step 2 of this fault. (12) If 24 vdc is present, replace windshield wiper motor (para 18-4). (13) Position windshield wiper switch to off (TM 9-2320-365-10). (14) Position master power switch to off (TM 9-2320-365-10). (15) Connect connector PX22 to windshield wiper motor.