TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 1267 of 1760
TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 2-871 2-871 2-871 2-871 2-871 CONTINUITY TEST CONTINUITY TEST (1) Remove instrument panel assembly for access (para 7-15). (2) Disconnect windshield wiper ECU from connector PX21. (3) Disconnect connector P18 from turn signal switch connector. (4) Set multimeter to ohms. (5) Connect positive (+) probe of multimeter to connector PX21-1. (6) Connect negative (-) probe of multimeter to connector P18-9 and note reading on multimeter. (7) If continuity is not present, repair wire 1599 (para 2-40) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to turn signal switch connector terminal 9. (3) Connect negative (-) probe of multimeter to turn signal switch connector terminal 5. (4) Position windshield wiper switch to intermittent (TM 9-2320-365-10) and note reading on multimeter. (5) If continuity is not present, replace turn signal switch (para 7-25). (6) Position windshield wiper switch to off (TM 9-2320-365-10). (7) Connect windshield wiper ECU to connector PX21. (8) Connect connector P18 to turn signal switch connector. (9) Install instrument panel assembly (para 7-15). (10) Install PDP on dashboard with three screws. (11) Install three washers and screws in PDP. (12) Install PDP cover (para 16-2).