TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 1199 of 1760
TM 9-2320-365-20-1 2-803 Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuits and cause severe burns or electrical shock. VOLTAGE TEST Remove plastic cable ties as required. (1) Disconnect connector P52R from connector J52. (2) Set multimeter to volts dc. (3) Connect positive (+) probe of multimeter to connector P52R-3. (4) Connect negative (-) probe of multimeter to ground. (5) Position main light switch to SER DRIVE (TM 9-2320-365-10) and note reading on multimeter. (6) If 12 vdc is not present, repair wire 489 (para 2-40) or replace rear lights cable assembly (para 7-75). (7) If 12 vdc is present, replace rear intervehicular 12 VDC (7 pin) cable (para 7-78). (8) Position main light switch to OFF (TM 9-2320-365-10). Install plastic cable ties as required. (9) Connect connector P52R to connector J52. NOTE WARNING NOTE