Covering the politics, Business and technology of defense - Subscribe Today

TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download

Page 1105 of 1760

CAUTION Change 1 2-716.1 TM 9-2320-365-20-1 Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. CONTINUITY TEST (1) Remove instrument panel assembly for access (para 7-15). (2) Disconnect turn signal switch connector from connector J19. (3) Position turn signal switch to center position (TM 9-2320-365-10). (4) Set multimeter to ohms. (5) Connect positive (+) probe of multimeter to turn signal switch connector socket 6. (6) Connect negative (-) probe of multimeter to turn signal switch connector socket 2 (LH) or socket 3 (RH) and note reading on multimeter. (7) If continuity is not present, replace turn signal switch (para 7-25). (8) Connect connector J19 to turn signal switch connector. (9) Install instrument panel assembly (para 7-15).