TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 1087 of 1760
TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 2-701 2-701 2-701 2-701 2-701 CONTINUITY TEST CONTINUITY TEST (1) Disconnect connector PX14 from hazard lights switch. (2) Set multimeter to ohms. (3) Connect positive (+) probe of multimeter to connector PX20-A. (4) Connect negative (-) probe of multimeter to connector PX14-6 and note reading on multimeter. (5) If continuity is not present, repair wire 1568 (para 2-40) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (6) Connect connector PX14 to hazard lights switch. (7) Install instrument panel assembly (para 7-15). (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to connector PX20-C. (3) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (4) If continuity is not present, repair wire 3049 (para 2-40) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (5) If continuity is present, replace flasher unit (para 7-24). (6) Connect connector PX20 to flasher unit. (7) Install flasher unit on dashboard with two washers and screws. (8) Install kick panel (para 16-3).