TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 1041 of 1760
CAUTION NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. CONTINUITY TEST Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuits and cause severe burns or electrical shock. Change 1 2-655 TM 9-2320-365-20-1 (1) Remove three screws from PDP. (2) Remove three screws and washers from PDP. (3) Lift PDP outward to gain access. (4) Disconnect connector P51 from connector J51. (5) Set multimeter to ohms. (6) Connect positive (+) probe of multimeter to connector PX33 socket A1. (7) Connect negative (-) probe of multimeter to connector J51 pin 2 and note reading on multimeter. (8) If continuity is not present, repair wire 490 from connector PX33 socket A1 to connector J51 pin 2 (para 2-40) or replace WTEC II dashboard cable assembly (para 7-10). (9) Connect connector PX33 to WTEC II VIM. (10) Tighten screw in connector PX33. (11) Install kick panel (para 16-3).