TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 1039 of 1760
CONTINUITY TEST CAUTION Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes. Failure to comply may result in damage to equipment. NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability. Check that connector pins are not pushed back and are capable of making good contact. Change 1 2-653 TM 9-2320-365-20-1 (1) Remove instrument panel assembly for access (para 7-15). (2) Disconnect connector J114 from WTEC II TEPSS. (3) Loosen screw in connector J116. (4) Disconnect connector J116 from WTEC II VIM. (5) Connect positive (+) probe of multimeter to connector J116 socket F2. (6) Connect negative (-) probe of multimeter to connector J114 socket 13 and note reading on multimeter. (7) If continuity is not present, replace WTEC II cab transmission harness (para 7-86). (8) Connect connector J114 to WTEC II TEPSS. (9) Install instrument panel assembly (para 7-15). (10) Connect connector J116 to WTEC II VIM. (11) Tighten screw in connector J116.