TM-9-2320-365-20-1 LMTV Unit Maintenance Manual M1078 Series - Volume 1 Download
Page 1015 of 1760
TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 TM 9-2320-365-20-1 2-629 2-629 2-629 2-629 2-629 CONTINUITY TEST VOLTAGE TEST Remove rings, bracelets, watches, necklaces, and any other jewelry before working around vehicle. Jewelry can catch on equipment and cause injury or short across electrical circuit and cause severe burns or electrical shock. WARNING (1) Set multimeter to ohms. (2) Connect positive (+) probe of multimeter to connector J62-A. (3) Connect negative (-) probe of multimeter to ground and note reading on multimeter. (4) If continuity is not present, repair wire 3050 (para 2-40) or replace warning light cable assembly (para 22-2). (5) If continuity is present, replace warning light (TM 9-2320-365-10). (1) Remove instrument panel assembly for access (para 7-15). (2) Set multimeter to volts dc. (3) Disconnect connector PX12 from warning light switch. (4) Position main light switch to SER DRIVE (TM 9-2320-365-10). (5) Connect positive (+) probe of multimeter to connector PX12-5. (6) Connect negative (-) probe of multimeter to ground. (7) If 12 vdc is not present, repair wire 1575 (para 2-40) or replace WTEC II dashboard cable assembly (para 7-10) or WTEC III dashboard cable assembly (para 7-11). (8) Position main light switch to OFF (TM 9-2320-365-10).