TM-9-2990-206-34&P Parts Manual, Tools and Maintenance for Turbocharger Model T18C01 Download
Page 48 of 85
ASSEMBLY—Continued. 7. On turbine wheel hubs that cannot be held with a box wrench (because of factory balancing), use improvised holding fixture (A) to keep turbine wheel from turning. Install compressor wheel (B) and nut (C) and torque tighten as in steps 4 through 6 above. INSTALL CENTER HOUSING, HEAT SHIELD, AND COMPRESSOR HOUSING TOOLS : 9/16 inch, 1/2 inch drive socket 7/16 inch, 1/2 inch drive deep socket Socket wrench handle (speeder) 1/2 inch drive, O to 300 pound- inches, torque wrench NOTE Table 3-1 provided information for proper indexing of the tur- bine and compressor housings according to engine model and mounting location. Table 3-1 applies to both “clean air” and standard turbosuperchargers. INSTALLATION: 1. Place turbine housing (A) on bench with studs down. 2. Aline alinement marks scribed during disassembly and install center housing (B) on turbine housing (A). If alinement marks cannot be located, or if either housing has been replaced, refer to Table 3-1 to determine proper housing position. TA293549 Change 1 3-23 TM 9-2990-206-34&P