TM-9-2990-206-34&P Parts Manual, Tools and Maintenance for Turbocharger Model T18C01 Download
Page 36 of 85
INSPECTION-Continued. INSPECT THRUST SPACER TOOLS: 0.3125 to 0.5000 inch telescope gage 0.00 to 1.00 inch micrometer 0.0015 to 0.025 inch blade thickness gage (feeler) 1. Inspect thrust spacer (A) for cracks, scoring, galling chipped edges or wear on end surfaces. End surfaces must be parallel within 0.0001 inch TIR (0.0025 mm TIR). 2. Measure bore diameter (C) using telescope gage and mi- crometer. Replace thrust spacer if bore diameter ex- ceeds 0.3758 inch (9.645 mm). Inspect grooves (D) for wear. Measure width of grooves (D)using thickness gage. Replace thrust spacer if groove width exceeds 0.0695 Inch (1.765 mm). 3. Replace thrust spacer if damaged, has groove wear, or does not meet wear limit requirements. INSPECT THRUST RING TOOLS: 0.00 to 1.00 inch micrometer 0.3125 to 0.5000 inch telescope gage 1. 2. 3. 4. 5. Inspect thrust ring (E) for scratches, scoring, and galling on inside surface (F) and bottom surface (G). Check to be certain oil passages (H) are clear. Surface (F) must be free of surface defects and have a smooth surface finish. End surfaces (J) and (K) must be parallel within 0.0003 inch (0.0076 mm). Surface (F) must be parallel to sur- face (L) within 0.0020 inch TIR (0.0508 mm TIR). Measure thickness (M) using micrometer. Replace thrust ring if thickness is less than 0.2990 inch (7.595 inn). Measure bore diameter (N) using telescope gage and micrometer. Re- place thrust ring if bore diameter exceeds 0.3758 inch (9.545 mm). K Measure thickness (P). Replace thrust ring if thickness is less than 0.0850 inch (2. 159 mm). Measure diameter (Q). Replace thrust ring if diameter is less than 1.1200 inch (28.45 mm). Replace thrust ring if damaged, or does not meet wear limit requirements. TAO97819 3-13 TM 9-2990-206-34&P