TM-9-2990-206-34&P Parts Manual, Tools and Maintenance for Turbocharger Model T18C01 Download
Page 21 of 85
TM 9-2990-206-34&P Section Il. GENERAL MAINTENANCE 2-3. GENERAL. Special tools, repair parts, and equip- ment over and above those available to the using organization are supplied to direct and general support units for maintaining and repairing the material. 2-4. COMMON TOOLS AND EQUIPMENT. For authorized common tools and equip- ment refer to the Modified Table of Organization and Equipment (MTOE) applicable to your unit. 2-5. SPECIAL TOOLS. A thread tap and screw thread inserter are required for repair of these turbo- superchargers. 2-6. IMPROVISED TOOLS. The holding fixture shown below applies only to direct and general sup- port units to enable these maintenance organizations to fabricate it locally. it is of chief value to units engaged in repairing a large nunber of similar components. However, it is not essential for repair and is not avail- able for issue. NOTE Fabricate from hard wood or aluminum. Drill eleven 0.375 inch (9.5 mm) holes equally spaced on the 5.25 inch (133.4 mm) diameter. Cut out 5.00 inch (127 mm) circle. Bottom block is solid. Assemble top and bottom blocks with screws or bolts. 2-7. REPAIR PARTS. Repair parts are listed and illustrated in Appendix B of this manual. TA07807 2-5/2-6 (blank)