TM-9-2990-205-34&P Parts Manual, Tools and Maintenance for Turbocharger Model 5HDR Download
Page 53 of 128
TM 9--2990--205--34&P 0010 00--3 INSPECTIONOF COMPONENT PARTS -- CONTINUED 0010 00 3. Inspection of Turbine Wheel and Shaft Assembly . CAUTION It is important to use extra care when checking for cracked blades. If undetected, they could break during operation and cause severe damage. a. Inspect turbine wheel and shaft assembly (1) for bent, cracked, broken, or missing blades, or a bent shaft. b. Using micrometer, check the diameter of the thrust area (2) of the shaft. The measurement must be from 0.5000 inch to 0.4997 inch. c. Using micrometer, check the length of the shaft (3) from thrust surface shoulder to inner face of turbine wheel. This measurement must be from 3.9860 inches to 3.9820 inches. d. Using micrometer, check the diameter of the bearing area of the shaft (4). This measurement must be from 0.6865 inch to 0.6862 inch. e. Inspect metal seal ring groove (5) for wear using gage (6). If “NO--GO” end of gage enters the ring groove, replace the turbine wheel end shaft assembly. f. Replace the turbine wheel and shaft assembly if damaged or if it does not meet the wear standards specified in the preceding steps. 03i476m 2 3 1 4 5 6