TM-9-2990-205-34&P Parts Manual, Tools and Maintenance for Turbocharger Model 5HDR Download
Page 51 of 128
TM 9--2990--205--34&P 0010 00--1 INSPECTION OF COMPONENT PARTS 0010 00 THIS WORK PACKAGE COVERS: Inspection INITIAL SETUP: Tools and Special Tools General mechanic’s tool kit (item 1, WP 0017 00) Magnifier (item 3, WP 0017 00) Gage, turbocharger (special tool) (Fig 4, item 1, WP 0015 00) Micrometer, outside (item 4, WP 0017 00) Micrometer, outside (item 5, WP 0017 00) Micrometer, outside (item 6, WP 0017 00) Telescope gage set (item 7, WP 0017 00) Equipment Condition Turbo components on work bench; cleaned and dried NOTE All components not discarded during disassembly must be thoroughly inspected according to the following procedures to determine if they can be reused in rebuilding the turbo. Some defects you may discover during inspection can be repaired (WP 0011 00); however, parts that are worn or damaged beyond repair must be replaced with new parts. Wear standards for turbo components are provided within the applicable inspection procedures. Use appropriate precision measuring instruments when checking for wear. When measuring inside or outside diameters, always take two measurements approximately 90 degrees apart to allow for possible out--of--round condition. When inspecting for cracks, use a strong light and magnifying glass.