TM-9-2990-205-34&P Parts Manual, Tools and Maintenance for Turbocharger Model 5HDR Download
Page 49 of 128
TM 9--2990--205--34&P 0009 00--1 CLEANING OF COMPONENT PARTS 0009 00 THIS WORK PACKAGE COVERS: Cleaning INITIAL SETUP: Tools and Special Tools Hard bristle brush (item 5, WP 0016 00) Plastic scraper (item 8, WP 0016 00) Goggles (item 6, WP 0016 00) Rubber gloves (item 7, WP 0016 00) Materials/Parts Solvent (item 3, WP 0016 00) Rags, wiping, cotton (item 1, WP 0016 00) Equipment Condition Turbo components on workbench NOTE After disassembly and before inspection, all component parts must be thoroughly cleaned according to the following procedure. CLEANING WARNING Cleaning solvent is flammable! Use only in well ventilated areas. Keep away from flame, sparks, or heat. Avoid contact with eyes, and wear rubber gloves to prevent skin irritation. 1. Immerse metal parts in solvent and clean with bristle brush and plastic scraper. Use clean cloth moistened with solvent to clean hard to reach areas. WARNING Line pressure for compressed air used for cleaning shall not exceed 30 psi. Wear appropriate eye protection and gloves. Never direct the compressed air at another person. CAUTION Never use caustic solution, wire brush, or steel blade scraper. 2. Clean all drilled passages with wire probe and compressed air. 3. Make certain all housing surfaces surrounding the turbine and compressor wheels are clean and smooth. 4. Blow all parts dry with compressed air. END OF WORK PACKAGE 0009 00--1/2 blank