TM-9-2815-220-34 Direct Support Manual for AVDS-1790-2C and AVDS-1790-2D Engines Download
Page 91 of 532
TM 9-2815-220-34 • Figure 2-12. Re111ovi11g or i11Jtolli11g starter _ 111011111i11g nuts. Figure 2-13. Remoui11g or in$talling starter assembly. b. lnstallatio11. (1) Install two bolts through transmission and starter adapter. Install new mounting asket. (fig. 2- 13) on starter adapter. Position starter assembly on starter adapter and position suitable blocks (fig. 2-12) under starter assembly for support. (2) Install two self-lking nuts on bolts and one selC-locking nut on stud (behind starter) using open end wrench Part No. 8761568 (fig. 2-12). (3) Posit. ion the assembled starter support (7, fig. 2-11) and cradle on oil pan and install three bolts and flat washers. (6) Tighten only until bolt heads engage the washers (fingertight). NOTE It is of utmost importance that the starter support, cradle, and "U" boll be installed in a manner that will not disturb starter mounting alinement and still furnish adequate support to minimize vibration. Misalinement of 0.010-in. in any direction is sufficient to cause a leak (pressure loss) between the starter mounting flange and the starter housing. (4) Loosen four screws (8, fig. 2-1 J ) , allow- ing cradle screws to move freely in elongated holes in support. Position the "U,, bolt (5) over the starter and secure to cradle with two clamping bars (4) and self-locking nuts (3). Tighten nuts evenly. (5) Tighten four screws (8, fig. 2-11) and three macltine bolts (6) securing starter support to oil pan. ' (6) Position starter low voltage protective module and bracket (2, fig. 2-1 J) on crankcase and secure with three machine bolts and lockwashers (I). (7) Install starter low voltage prote�ive mod- ule electrical lead and secure to srarter with machine screw (I 0, fig. 2-10). JnstaU machine bolt and lockwasher (2) on cable clamp and secure to module bracket. (8) Install starter low voltage starter protective module electrical lead (9) and two starter cables (8) on battery terminal and secure with hexagon nuts and lockwasllers (7). (9) Install two wiring haess cables (4) and electrical lead (5) on starter terminal and secure with hexagon nut and lockwasher (3). Connect wfring haess electrical lead (1) to starter low voltage protective module. · (10) Install machine bolt and two flat washers (6) on electricaJ lead (5) and secure to starter support. Cha nge 3 2·35