TM-9-2815-220-34 Direct Support Manual for AVDS-1790-2C and AVDS-1790-2D Engines Download
Page 378 of 532
TM 9-2815-220-34 c. Install Jcft hand rod end plain bearing (24) and right hand rod end plain bearing (10) on goveor control rod (12). Tighten hexagon plain nuts (11) and (23 ). 111e goveor control rod should be approximately l 0.92 inches long. Install dust and moisture boot (3) and two hose clamps (2) on yieldable control rod assembly (6). Tighten hose clamps. 18 f I Hexagon head capscrew 2 !lose cl3mp 20 3 Dusl and moisture seal boot 4 Flat washer S Hexagon self-locking nut 6 Yicldable control rod aembly 7 Bell crank 8 ckwasher 9 Hexagon head capscrew 10 Rorl end plain bearing 11 Hexagon plain nut 12 Governor control rod d. Deleted e. Install two needle roller bearings (11, fig. 3-259.1) and one encased plain seal (12) in inner solenoid control housing(lO). Install inner solenoid control housing on throttle control straight shaft (17), with two flat washers (13) and two retaining j 13 Straight shaft 14 Retaining ring IS Reph1cemcnt bearing shield 16 Annular ball bearing 17 Retaining ring 18 Ro tat i11g eye bracket 19 Spacer 20 Extension helical spring 21 Angle bracket 22 Woodruff key 23 Hexagon plain nut 24 Rod end plain bearing (left hand thread) 2 2 \ � ) � 3 TA265703I Fiuure 3·259.2. Cr , lever1, and a11ociated s, mI AV DS·1790·2D R ee. 3· 166 Change 3 ) )