TM-9-2815-220-34 Direct Support Manual for AVDS-1790-2C and AVDS-1790-2D Engines Download
Page 372 of 532
TM 9-2815-220-34 1-ing (52) and using a suitable puller, remove cross shaft governor control lever assembly (56), two bearings (51), and two retaining rings (53) as an assembly. e. Remove retaining 1fog (52) and two throttle shock sp1fog flat washers (57) and shock spring (58). Removecapscrew(44) and lockwasher(43) and remove throttle control lever assembly (42). Re- move woodruff key (49 from cross shaft(26). . Remove two retaining rings (32) and two spac- ers (31) and remove manual fuel shut off control lever assembly (27) from cross shaft (26.) g. Remove capscrew (39), lockwasher (40), and remove intermediate goveor control lever (12) and woodruff key (9) from governor control lever bearing shaft (36). Remove two retaining rings (1) and remove two dust shields (2) and intermediate governor control lever support (5), two ball bear- 3-160 Change 1 ings (3), and two retaining rings (4) from bearing shaft as an assembly. Remove the two retaining rings, dust shields and ball bearings from the sup· port. h. Remove two retaining rings (33) and the ball bearing (51) from the throttle control cross shaft bracket(35). Remove two ball bearings(51) and two retaining rings (53) from the cross shaft governor control lever assembly (56). Loosen two nuts (37) and remove the left hand and right hand rod end bearings (11) from the goveor control rod (41). NOTE The rod bearings on the intermediate governor lever connection link are pinned and are not to be disassembled. i. Remove two oil seals (<) and two bearings (29) from manual fuel shutoff lever(30). ) )