TM-9-2815-220-34 Direct Support Manual for AVDS-1790-2C and AVDS-1790-2D Engines Download
Page 173 of 532
(e) Remove self-locking nut and flat washer (1, fig. 2-148) and disconnect ground strap (2). Install self-locking nut and nat washer. Remove I screw and two nat washers (3) and remove ground strap. Remove capscrew and Jockwasber (4) and remove cable terminal (5). Remove cable connect- or (6). Remove wiring harness, generator cable, clamp and brackets as outlined in paragraph 2- 4 l(k) through (n ) . (2) Installation (a) Install generator cable, wmng harness, clamps and brackets as outlined in par agraph 2- 49a2(a) through (d). (b) Install cnble connector (6, fig. 2-148) on generato r blower motor. Install capscrew and lockwasher (4) on cable terminal (5) and secure t o crankcase. Install g1·ound strap (2) o n generator terminal and secure with self-locking nut and flat washer (l ). llstall ground strap on generator cradle I and secure with screw and two flat washers (3). TM 9-2815-220-34 2 TA265664 I Self-locking nut and nat washer 2 Ground slrnp 3 Screw and nat washer 4 CJpscrew and lockwasher S Ƣble terminal 6 Cable connector Figure 2·1 . RcmotJing nr i1111nlli11g generator coble co11nector a11d g roud strap. Change 3 2-90.1 (2-90.2 blank)