TM-9-2815-220-34 Direct Support Manual for AVDS-1790-2C and AVDS-1790-2D Engines Download
Page 172 of 532
TM 9-2815-220-34 ) Install bracket assembly (fig. 2-136) and secure· to oil cooler frame with two capscrews and self -locking nuts. Install three retaining straps and secure to the two bracket assemblies with six cap. screws and self-locking nuts. Install manifold pre· heat cable connector. (k) Install loop clamp (fig. 2·135) on starter cable and secure to intake manifold with self-lking nut. Install lꝏp clamp on starter cable and secure to crankcase with capscrew and self-locking nut. Install loop clamp on wiring harness and secure to crankcase with capscrew and self-lockirag nut. (l) Install starter low voltage protective module cable terminal lug (I 0, fig. 2· l 34 ) , and two starter electrical cables (9) (circuit No. 81) on battery terminal and secure with hexagon nut and lockwasher (8) . . (m) Insl all capscrew and flat washer (7j on ground strap (6) and secure to starter support. (n} Install starter ground strap (6) and two starter ground cables (5) and secure with hexagon nut and lockwasher (4). Install starter low voltage protec- tive module cable connector (3). Install loop clamp (2) on starter cables and wiring harness and secure to crankcase with capscrew and lkwasher (1). b. Mel AVDS-l 790-2D. (1) Removal (a) Remove starter cables and wiring harness as outlined in paragraph 2-49al(a) through (h). (b) Remove two capscrews, lockwasher and flat washers (fig. 2-146) and remove generator air intake tube from generator blower motor housing. Figure 2-146. Remouing or ir•a/ling gcneraror oir in rake rube, AYDS·l 790.2D. (c) Remove oil temperature and oil pressure cable connectors and wiring harness as outlined in par. 2-49a, (i). 2-90 Change 3 (d) Remove four machine screws, lkwashers and hexagon nuts (1, fig. 2-147) and remove trans- mission disconnect cable connector (2) from bracket (3). Remove self-lking nut and flat washer (4) and remove generator cable (5) and electrical cable (6) and (7). Install self -lking nut and flat washer. Remove self-locking nut and flat washer. Remove self -locking nut and flat washer (8) and remove elec· trical cable (9). Install self -lking nut and flat washer. Remove self-lking nut and flat washer (10) and remove electrical cable (11). Install self-locking nut and flat washer. 1 Machine screw, lkwashcr and hexagon nul 2 Cable conneclor S Bracket 4 lf-lking nul and Oal washer 6 Generalor cable 6 Eleclrical cable 7 Electrical cable 8 Self-locking nul and nat washer 9 Electrical cable 10 lC·lking nut and flat washer 11 Electrical cable figure 2·147. Removing or inllo//i11g generator electrical coble and wirin+ harness, AYDS.J 790·2D.