TM-9-2815-220-34 Direct Support Manual for AVDS-1790-2C and AVDS-1790-2D Engines Download

Page 168 of 532

TM 9-2815-220-34 I Figure 2-137. Re111q111i1g or i11stolli11g starter coble 11101111ti11g bracket, ely engines. F ig ur e 2-138. Remo11ing or imtalling el aolenuid and el &l1utff connector. 2·86.2 Change 2 Figure 2-139. Removing or in31alli11g el/woter 3eparator cable tonnector. ('1) Remove two capscrews and lockwashers (fig. 2-139) and remove two lꝏp clamps. Cut tie-wrap and remove fuel/water separator cable connector. Remove capscrew and lockwasher and remove lꝏp clamp. Remove capscrew and lockwasher and remove bracket. (i) Remove two capscrews, lockwashers and hexagon nuts (1, fig. 2-140) and remove two lꝏp clamps (2). Remove two capscrews and lockwashers (3) and remove two brackets (4). Remove two cap- screws and lockwashers (5) and remove two lꝏp clamps (6). Remove hour meter cable connector (7) and self-lking nut (8) and remove loop clamp (9). Remove high oil temperature switch cable electrical connector shell (10), oil pressure transmitter cable electrical connector shell (11), oil temperature trans· mitter cable electrical connector shell (12), and low oil pressure cable electrical connector shell (13). ) Remove two generator wiring harness cable connectors (1 and 2, fig. 2-141). Remove four machine screws, lkwashers and hexagon nuts (3) and remove transmission disconnect cable connector (4). Remove self -lking nut and flat washer (5) and remove assembled buss bar and generator cable (6). InstaJJ flat washer and self-locking nut. Remove self- locking nut and flat washer (7) and disconnect assembled buss bar and ground strap (8). Install self-Jocking nut and flat washer. Remove capscrew and flat washer (9) and remove assembled buss bar and ground strap (8).