TM-9-2815-220-34 Direct Support Manual for AVDS-1790-2C and AVDS-1790-2D Engines Download
Page 157 of 532
1 T i e-wra p 2 Wiring harness electrical lead 3 Machine screw and clamp 4 Wiring harness lead 5 Control mule 6 Assembled washer boll and clamp 7 Aembled washer bolt 8 Filter drain hose 9 lenoid valve 10 Wiring harness lead 11 Drain tube 12 Aembled washer ll 13 Ni p ple 14 El w 15 Probe lead wires surc 2-123. Remot·ing ur i1Utolli11g elater Jeporator filter autonwtic rain co11tr ol module or Jo/enoid 1·al11e. b. /11$tallation. (1) Install control module (5, fig. 2-17) and secure with three assembled washer bolts (7) and assembled washer bolt and cushioned clamp (6). Con- nect wiring harness lead (4) to control rrodule. Install cushioned clamp and machine screw (3) securing probe lead wires (15) to cylinder deflector. (2) Install nipple (13) in solenoid "IN" opening and elbow (14) in "OUT" opening. Install the solenoid valve on mounting bracket and secure with two assembled washer bolts (12). Install solenoid valve drain tube (11) and connect wiring harness lead (10) and filter drain hose (8). Connect wiring harness electrical lead (2) and install new tie - wrap (1). (3) Install two water level probes (f ig. 2-16) I making sure that the upפr probe, identified by red TM 9-2615-220-34 shrink tube, is in the upper boss on the fuel/water I separator filter. Install cushioned clamp, lock- washer and capscrew on fuel filter. Tighten two lower and two upper capscrews. (4) Close drain cock (fig. 2-62). Purge fuel system and close bleeder valve (fi g . 2-122). 2·45. Starter Low Voltage Protective Module-Early Engines a. Remo11a/. Disconnect wiring haess. Remove two capscrews, insulator washers and self-locking nuts (fig. 2-124) ancl remove motlule from mount- ing bracket. b. Installation. Install module (fig. 2- I 24) on mounting bracket and secure with two capscrews, insulator washers and self-locking nuts. Connect wiring haess. 2·45.1. Starter Low Voltage Protective Module-Late Engines a. Removal. Disconnect wiring haess from starter low voltage protective module (fig. 2-124. l). Remove two capscrews and lockwashers Figu�e 2-124. Remocins or inJto//ing 11orter 110/tage protective module. and remove wiring haess ground lead and mod- ule. b. J11slallalion. Position module (fig. 2-124.1) on mounting bracket and secure module and ground lead with two capscrews a;1d lockwashers. Connect wiring harness. Change 3 2-79