TM-9-2815-220-24 Maintenance Manual for AVDS-1790-2CA AVDS-1790-DA and AVDS-1790-2DR Engines Download
Page 988 of 1563
TM 9-2815-220-24 THROTTLE CONTROL AND MANUAL FUEL SHUTOFF (2CA, 2DA) 0122 00 CLEANING 1. See Work Package 0028 for General Cleaning Procedures. INSPECTION All parts must be inspected with care. Replace parts if damage or wear exceeds allowable limits. 1. See Work Package 0028 for General Inspection Procedures. 2. Measure outside diameter of straight shaft (15) at points (A and B), using outside micrometer (item 17, WP 0176). a. Replace shaft if measurement is not within limits in the following table. Location Sizes and Fits of New Parts inches (mm) Wear Limits A (Bearing areas) 0.6249 (15.87) 0.6252 (15.88) 0.6246 (15.86) B (Fuel shutoff lever) 0.6232 (15.83) 0.6252 (15.88) 0.6217 (15.79) 3. Visually inspect throttle lever housing (8) and pin (45). 1 A A B 5 4. Visually inspect fuel shutoff lever assembly (23). Refer to WP 0028. (Sleeve bearings (46) will be replaced in "Repair" of this work package.) 46 46 23 45 8 WP 0122 00-6