TM-9-2815-220-24 Maintenance Manual for AVDS-1790-2CA AVDS-1790-DA and AVDS-1790-2DR Engines Download
Page 931 of 1563
TM 9-2815-220-24 FUEL INJECTION NOZZLE REPLACE/REPAIR 0114 00 INSPECTION 1. Inspect seat of nozzle valve (27) for evidence of wear, distortion due to pounding, discoloration due to overheating, and pitting. Reject if found. 2. Inspect the valve stem of nozzle valve (27) for scratches and discoloration. Reject if found. 3. Check the fit of nozzle valve (27) in nozzle body (28) by lifting the valve about one-third of its length out of the body. The valve should slide back to its seat without aid when the nozzle tip (26) is held at a 45-degree angle. Reject both pieces if they fail this test. 4. Inspect eight spray orifices in the nozzle tip (26) and the drilled passage for freedom of obstructions. Replace if obstructed. 5. Inspect lapped sealing surfaces of nozzle body (28) for cracks, scratches, discoloration, wear, pitting and evidence of pounding. Reject if found. 6. Inspect the lapped sealing surfaces on the ends of the spacer (11) for scratches, discoloration, and cracks. Reject if found. 7. Inspect the area around the center hole on nozzle end of spacer (11) for evidence of wear and pounding by the nozzle body (28). Maximum allowable depth of wear or distortion due to pounding at this area is 0.003 inch (.0762 mm). 27 26 11 28 WP 0114 00-11