TM-9-2815-220-24 Maintenance Manual for AVDS-1790-2CA AVDS-1790-DA and AVDS-1790-2DR Engines Download

Page 919 of 1563

TM 9-2815-220-24 FUEL INJECTION TUBES REPLACEMENT 0113 00 INSTALLATION (Continued) CAUTION 1 1 3 2 Support nuts (1) on ends of each fuel injection tube must be tightened after the compression nut (2) [nozzle end] or compression connector (3) [pump end] has been torque tightened. The compression nut or compression connector must be held in place while tightening the support nut. Failure to comply may result in damage to fuel injection tubes. 17 1 2 21. Tighten injector tube compression nuts (2) to 300 inch-pounds (34 Nm) at each nozzle (17). 22. Tighten support nuts (1) to 125 inch-pounds (14 Nm) at each nozzle (17). CAUTION Inspect all lines and clamps for 1/8 inch (3.175 mm) minimum clearance with exhaust manifold, fan towers, and cooling fans. Contact of fuel lines to each other is not permissible. END OF WORK PACKAGE WP 0113 00-15 (16 blank)