TM-9-2815-220-24 Maintenance Manual for AVDS-1790-2CA AVDS-1790-DA and AVDS-1790-2DR Engines Download
Page 917 of 1563
TM 9-2815-220-24 FUEL INJECTION TUBES REPLACEMENT 0113 00 INSTALLATION (Continued) 17. Install floating clamp in location shown in illustration (see detail H). CAUTION When bending injection tubes is required, be careful not to nick tubing. The bending tools are designed to allow bending without nicks. a. Assure that clamp half (38) does not interfere with cooling fan and that tubes are parallel with each other. Use two bending tools (24) (item 13, WP 0177). b. Apply a small amount of Lubriplate (item 23, WP 0173) to threads of one screw (39). c. Install clamp halves (38, 40), using screw (39) with new self-locking nut (41) (item 111, WP 0175) and two flat washers (42) as shown. d. Tighten screw (39) to 75-100 inch-pounds (8.5-11.3 N•m). Left Bank Right Bank Damper End H 24 41 40 38 42 42 39 H WP 0113 00-13