TM-9-2815-220-24 Maintenance Manual for AVDS-1790-2CA AVDS-1790-DA and AVDS-1790-2DR Engines Download
Page 916 of 1563
TM 9-2815-220-24 FUEL INJECTION TUBES REPLACEMENT 0113 00 INSTALLATION (Continued) 16. Install floating clamps in location shown in illustration (see detail G). CAUTION When bending injection tubes is required, be careful not to nick tubing. The bending tools are designed to allow bending without nicks. a. Assure that fairlead halves (28) are aligned with tubes to fit within 1/8 inch (3.175 mm) in any direction. Use two bending tools (24) (item 13, WP 0177). b. Apply a small amount of Lubriplate (item 23, WP 0173) to threads of four screws (25). c. Install retainers (30) fairlead halves (28), and strap (37) using screws (25) with new self- locking nuts (27) (item 38, WP 0175). d. Tighten screws (25) to 160-180 inch-pounds (18-20 N•m). Damper End Left Bank Right Bank 25 30 37 27 28 30 G 24 G WP 0113 00-12