TM-9-2815-220-24 Maintenance Manual for AVDS-1790-2CA AVDS-1790-DA and AVDS-1790-2DR Engines Download
Page 913 of 1563
TM 9-2815-220-24 FUEL INJECTION TUBES REPLACEMENT 0113 00 INSTALLATION (Continued) 11. Check that all tube assemblies have 1/8 inch (3.175 mm) minimum clearance to each other at pump end. Bend tubes as necessary, with bending tools (24) (item 13, WP 0177) to obtain clearance. CAUTION When bending of tube assemblies is required at the pump end, the compression connector and support nut must be re-torqued. Tighten compression connector to 35 foot-pounds (48 N•m). Tighten support nut to 125 inch-pounds (14 N•m). 12. Install 12 lower fairlead halves (28) between tube assemblies and brackets (33) at each cylinder. CAUTION When bending injection tubes is required, be careful not to nick tubing. The bending tools are designed to allow bending without nicks. 13. Assure that fairlead halves (28) are aligned with bracket (33) holes and align tube to fit within 1/8 inch (3.175 mm) in any direction with fairlead half. Use two bending tools (24). Damper End Right Bank Typical (12 places) Left Bank 24 28 33 WP 0113 00-9